In a series resonant LCR circuit, the voltage across R is 100 volts and R = 1 kΩ with C = 2µF. The resonant frequency ω is 200 rad/s. At resonance the voltage across L is
4 × 10−3 V
2.5 × 10−2 V
40 V
40 V
Two voltameters one of copper and another of silver, are joined in parallel. When a total charge q flows through the voltameters, equal amount of metals are deposited. If the electrochemical equivalents of copper and silver are z1 and z2 respectively the charge which flows through the silver voltameter is
A circuit has a resistance of 12 Ω and an impedance of 15 Ω. The power factor of the circuit will be
0.8
0.4
1.25
1.25
The phase difference between the alternating current and emf is π/2. Which of the following cannot be the constituent of the circuit?
C alone
R.L
L.C
L.C
Alternating current can not be measured by D.C. ammeter because
A.C. cannot pass through D.C.
A.C. changes direction
average value of current for complete cycle is zero
average value of current for complete cycle is zero
C.
average value of current for complete cycle is zero
The full cycle of alternating current consists of two half cycles. For one half, currently is positive and for second half, current is negative. Therefore, for an a.c. cycle, the net value of current average out to zero. While for the half cycle, the value of current is different at different points. Hence, the alternating current cannot be measured by D.C. ammeter.
In an LCR series a.c. circuit, the voltage across each of the components, L, C and R is 50 V. The voltage across the LC combination will be
50 V
50√2 V
100 V
100 V
In a LCR circuit capacitance is changed from C to 2C. For the resonant frequency to remain unchanged, the inductance should be changed from L to
4L
2L
L/2
L/2
For an RLC circuit driven with a voltage of amplitude vm and frequency the current exhibits resonance. The quality factor, Q is given by:
An EM wave from air enters a medium. The electric fields are
in air and in medium, where the wave number k and frequency v refer to their values in air. The medium is non-magnetic. If refer to relative permittivities of air and medium respectively, which of the following options is correct ?
If the rms value of sinusoidal input to a full wave rectifier is , then the rms value of the rectifier's output is
V02/2